What would an RF test technician being testing and measuring mostly?

1.) RG Gain
2.) Gain Flatness
3.) Return loss
4.) Gain Compression
5.) What else?

 

Everything else!!

 

As an unpaid Ham Radio enthusiast, I have measured hundreds more RF parameters in receivers, preamplifiers, transmitters, antennas, feedlines, modulators, demodulators, grounds, etc....

 

This sounds like where they have you sit down at a bench. Insert a board into a jig. Press a series of buttons....look at a series of indicators........and then put board in good pile or bad pile.
The title of the job was rf test tech.

 

Noise Figure
Gain
Linearity
IM3
3rd order intercept
Image rejection
Isolation
S11-S22-S12-S21
P1dB
Conversion Gain / Loss
S/N Ratio
Carrier Phase Noise
Frequency Stability
Frequency Responce


To name a few....
Mini Circuits Labs has some really good tutorials on these subjects... An even BETTER Source is www.microwaves101.com