Rectifying signal

Discussion in 'The Projects Forum' started by nad, Feb 12, 2009.

  1. nad

    Thread Starter New Member

    Feb 9, 2005
    6
    0
    Hi everyone,

    This is my first post, so please forgive my ignorance of proceedures.
    I have been trying to make a precision rectifier for my design; output to be fed to a PIC. I have found that the circuits shown can produce full wave rectification. However, I have found that placing a smoothing capacitor at the output will not produce a steady DC signal and the outputs remain half-wave AC signals.

    I have therefore designed a new circuit combining two half-wave rectifiers. I have also integarted CMR into my design. I would like to publish my design on this page but not sure how to isert the schematics.

    I will be grateful for your assistance.

    Many thanks
    Nader
     
  2. mik3

    Senior Member

    Feb 4, 2008
    4,846
    63
    Welcome to the forum then ;)

    It is not good to hijack other people post so start a new thread and post your circuits.

    You can attach the circuits by using the attachment clip on the tool bar above.
     
Loading...