RC Motor Control

Discussion in 'The Projects Forum' started by xoxorockoutloud123, Jun 20, 2013.

  1. xoxorockoutloud123

    Thread Starter New Member

    Jun 17, 2013
    16
    0
    I have 2 seperate DC motors which I would like to control independently of each other with a single RC transmitter and receiver. I want to raise and lower the speeds of these motors seperate of each other; for example, putting one motor to full speed and being able to lower the other motor. As stated before, I want to use only one RC transmitter and receiver. How should I accomplish this? Also, none of these motors are servos. They are all brushless DC motors.
     
  2. Dodgydave

    AAC Fanatic!

    Jun 22, 2012
    5,005
    745
    You need a two channel receiver at least so you can set the speeds of each motor seperately, by using a pwm control signal your going to need a variable dc output from your receiver channel , or a set of binary output for servo control.
     
  3. xoxorockoutloud123

    Thread Starter New Member

    Jun 17, 2013
    16
    0
    Could I possibly use two Electronic Speed Controllers instead of a pwm? Any recommendations on receivers?
     
Loading...