Problem with Proteus PCB design - Border Edge

Discussion in 'General Electronics Chat' started by Dritech, Feb 22, 2016.

  1. Dritech

    Thread Starter Well-Known Member

    Sep 21, 2011
    756
    5
    Hi,

    Can someone guide me on how to make a custom board edge on Proteus?
    I tried using "2D Graphics Line Mode" and "2D Graphics Arc Mode" but they are not forming the PCB when viewed using 3D visualizer.

    Any kind of help would be highly appreciated.
     
  2. StayatHomeElectronics

    Well-Known Member

    Sep 25, 2008
    864
    40
    Are you putting the board edge drawing on the correct layer? There is usually specific Board Outline layer in the PCB software package.

    Disclaimer: I have never used Proteus software so my advise may be totally wrong.
     
Loading...