Piezo Sensors

Discussion in 'The Projects Forum' started by jlestudios, Jun 28, 2011.

  1. jlestudios

    Thread Starter New Member

    Jun 28, 2011
    3
    0
    Hello Everyone,

    I am definitly not an electronics expert but I know a little bit.

    I am trying to make a custom guitar hero drum kit for the game Phase Shift. I have pulled apart my guitar hero drums and pulled the brain, piezo sensors, and circuit boards. I DO KNOW how to set it all back up. What I dont know is if I can do something.

    The Guitar Hero drum kit has a yellow, red, blue, green, and orange pad that you can hit and registers as a different button. I would like for my custom kit to contain 2 yellow, blue, and green but I want the 2 yellow to go into the same input of the circuit board same with the blue and green.

    Since piezos emit a charge when struck I figured I could just splice the wires from 2 sensors to the main input line for each but then wouldnt the piezo when struck send a signal to the other piezo on the same line and burn it out or something.

    I really appreciate anyones help on how I can get too different Piezo lines to the same input.

    Thanks
     
  2. jlestudios

    Thread Starter New Member

    Jun 28, 2011
    3
    0
  3. jlestudios

    Thread Starter New Member

    Jun 28, 2011
    3
    0
    Bump Please

    Sorry didnt need to bump I was looking in the wrong forum
     
Loading...