Hi, could someone tell me the best thin bear wire to use for PCB corrections. Basically I need to move 3 switches on my PIC; 44-pin TQFP. I need very thin bear wire to make a bridge from the new PORTS to my switches on my board. Any suggestions? RS components is likly where i will procure from.


Thanks

 

Can you show us a picture of your board

 

Not really tbh. I just need to know the preffered Tinned Copper Wire that would be suitabe for this work as per the chip package I stated.

Thanks

 

Solderable magnet wire might be a better choice.

 

Thin wire wrap cable perhaps. I have used this my self to mod PCBs.

 

Cheers, I just decided to bear back a some wire i had and used 1 strand from it. perfect size.

Thanks

 

Polar bear wire. But Brown or Black bear wire OK. Just do not use Grizzly bear wire. This is unBAREable.