Working on a welding table that was scrapped.

It uses a 90vdc motor controlled be Pacemaster PM1F control.

All 10 wires from the terminal strip have been cut and the control pendant is missing.

I'm finding information on google but nothing helpful yet.

If someone has worked on one or can find a link to a diagram it will help me out.

This is similar, (from ebay) excepting mine has a tach option board with shield wires going to motor.

 

Found it I think.
http://www.torquesystems.com/downloads/dc_drives/AO-7281_PM1_2 Manual.pdf

I knew if I asked for help it would pop up.

 

Working on a welding table that was scrapped.

It uses a 90vdc motor controlled be Pacemaster PM1F control.

All 10 wires from the terminal strip have been cut and the control pendant is missing.

I'm finding information on google but nothing helpful yet.

If someone has worked on one or can find a link to a diagram it will help me out.

This is similar, (from ebay) excepting mine has a tach option board with shield wires going to motor.

And, do you have a picture with the wires,???