P channel mosfet in series

Discussion in 'General Electronics Chat' started by jom, Jan 16, 2013.

Thread Status:
Not open for further replies.
  1. jom

    Thread Starter New Member

    Jan 16, 2013
    8
    0
    hi

    i have a question regarding the series connection of mosfet in my circuit ,
    actually i had to disconnect the load when the battery goes low which is monitored by a comparator which sends a high signal to the CTL pin of LTC4412, but when this happens the mosfet F2 intrinsic diode conducted so to overcome that i used F1 in series,

    can i use it like this ?? or can i just change the soucre and drain of F2 ??i have attached the schematic.
     
  2. bertus

    Administrator

    Apr 5, 2008
    15,648
    2,348
Loading...
Thread Status:
Not open for further replies.