overload protection on woodworking motor

Discussion in 'General Electronics Chat' started by pdoubleu, Feb 12, 2013.

  1. pdoubleu

    Thread Starter New Member

    Feb 12, 2013
    1
    0
    Hello. I received a new table saw motor today , with no diagram for the reset switch.
    The motor is 230v , 8amp. Two black wire come out of the motor, there are two black wires on the reset switch and three wire to go to the motor. Black white and green. Any clues how to wire the reset?
     
  2. #12

    Expert

    Nov 30, 2010
    16,343
    6,828
    Maybe this.
     
  3. SgtWookie

    Expert

    Jul 17, 2007
    22,182
    1,728
    Just a couple of corrections on #12's schematic (color, typo):

    [​IMG]
     
  4. #12

    Expert

    Nov 30, 2010
    16,343
    6,828
    Hmmm...given that this is a 230 volt circuit, in U.S.A. the neutral reference is wrong. In Europe, it is probably right. Pdobleu should tell what country the wires are in.
     
Loading...