orcad pspice schematic into symbol

Discussion in 'Electronics Resources' started by mirko, Sep 16, 2009.

  1. mirko

    Thread Starter New Member

    Sep 16, 2009

    how can i put a schematic i draw with orcad capture into a symbol?

    the schematic consists of parts which are in a pspice library, so the simulation of this cirquit is possible.
    but how can i put this cirquit into an own symbol so that i can use it in other schematics and also simulate them?
    is it also possible to put a schematic into a still existing symbol of an orcad library to "fill it with life" ?