Need Orcad symbol files for ADC0804

Discussion in 'Electronics Resources' started by pratapkollu, Jan 28, 2008.

  1. pratapkollu

    Thread Starter Active Member

    Dec 13, 2006
    42
    0
    Hello Dear Members
    I need orcad symbol/foot print files for ADC0804, DS89C420/430/450 & 74HC125
    Can any one help me plz

    Thanks and Regards
    Pratap
     
  2. scubasteve_911

    Senior Member

    Dec 27, 2007
    1,202
    1
    Sorry, I don't have them. But a word of advice!

    Get used to drawing symbols and footprints, it just goes with the territory of being a board designer. I have to draw about 33% of the components that I use no matter how well equipped my altium library is.

    Steve
     
  3. pratapkollu

    Thread Starter Active Member

    Dec 13, 2006
    42
    0
    Respected Steve
    Thank you for the advice, but I am sorry to say that I am from Materials Sci and Engg department. I know little abt this drawing symbols and footprints.
     
  4. thingmaker3

    Retired Moderator

    May 16, 2005
    5,072
    6
    Its not hard to learn. Sit down with the Orcad manual and a vernier caliper and your components. Half an hour later, you'll be an expert.
     
  5. nanovate

    Distinguished Member

    May 7, 2007
    665
    1
    The datasheets and manufacturer's website often have recommended footprints you can reference when making your own.
     
  6. kender

    Senior Member

    Jan 17, 2007
    263
    0
Loading...