Need help with a Sequential Turn Signal for my 350Z

Discussion in 'The Projects Forum' started by adamtaylorpcb, Feb 3, 2011.

Thread Status:
Not open for further replies.
  1. adamtaylorpcb

    Thread Starter New Member

    Feb 3, 2011
    4
    0
    i need plans for a Sequential Turn Signal for my 350Z. I need it to run off of my 12v car battery.

    i want it to operate just like this one

    http://www.youtube.com/watch?v=bbG8K_eVdZE

    but im going to be using an directional arrow or spaced vertical bars.

    im thinking about 10 zones with a stagger effect leaving the previous 2 zones and the active zone on so there are constantly 3 zones lit as it moves across the housing.

    i dont know if any of this is possible as i dont know much about making electronics... im good with a soldering iron and i can follow directions but i couldnt tell you what half of the symbols i see on this site mean.

    please help me, i really need it because this is like reading Hebrew to me right now

    Thank you
    Adam
     
  2. bertus

    Administrator

    Apr 5, 2008
    15,647
    2,346
Loading...
Thread Status:
Not open for further replies.