Need help with a Sequential LED board

Discussion in 'The Projects Forum' started by adamtaylorpcb, Feb 3, 2011.

Thread Status:
Not open for further replies.
  1. adamtaylorpcb

    Thread Starter New Member

    Feb 3, 2011
    i need plans for a Sequential led light board. I need it to run off of my 12v car battery for use in my new audio install.

    i want it to operate just like this one except it will be used in a different application.

    but im going to be using an directional arrow or spaced vertical bars.

    I want the LED's to be bright as hell because i plan on blacking out the enclosure with a tint type of material and i still want decent light transmitted

    im thinking about 10 zones with a stagger effect leaving the previous 2 zones and the active zone on so there are constantly 3 zones lit as it moves across the housing.

    i dont know if any of this is possible as i dont know much about making electronics... im good with a soldering iron and i can follow directions but i couldnt tell you what half of the symbols i see on this site mean.

    please help me, i really need it because this is like reading Hebrew to me right now

    Thank you
  2. bertus


    Apr 5, 2008

    For the THIRD time !
    Leaving out the 350Z will not help.
    Sorry, we do not allow any homemade changes to the lightning of a vehicle:
    Automotive Guidelines

    A walking light will be distracting.

Thread Status:
Not open for further replies.