need help with a circuit for my motorcycle

Status
Not open for further replies.

Thread Starter

tdubliture

Joined Sep 3, 2009
13
so I have come up with my own run turn brake circuit but I have some issues with it. I have not physically tested the circuit so im not sure if it will even work but one thing I do know is that the coil impedance is 230 ohms. This in parallel with the 10k resistor makes for an impedance around 225 ohms. To get the required time constant (around 2 seconds) I have to use a huge 10k uf cap. I don't know where I can hide this on my bike!!! So my question is. What are my alternatives?
can I use a transistor to turn on the relay? thus making impedance lower?
an optical isolator? don't know anything about them
????
I am open to suggestions and any help is appreciated.
 

Attachments

bertus

Joined Apr 5, 2008
22,266
Hello,

I am closing this thread as it violates AAC policy and/or safety issues.

Quote:
6. Restricted topics. The following topics are regularly raised however are considered “off-topic” at all times and will results in Your thread being closed without question:

  • Any kind of over-unity devices and systems
  • Automotive modifications
  • Devices designed to electrocute or shock another person
  • LEDs to mains
  • Phone jammers
  • Rail guns and high-energy projectile devices
  • Transformer-less power supplies
This comes from our Tos:
Terms of Service
There will be enough sites where automotive questions can be discussed :
Member selected automotive forums

Bertus
 
Status
Not open for further replies.
Top