I bought 4 sets Xmas led lights that each one have the 8 program ek-04 mini controller.
I want all of them to be in a same sequence when i light them up. Is it ok to remove the controller from each one and to connect all the four set to a single ek-04 mini controller? we have the 220v power supply.

 

Is it ok to remove the controller from each one and to connect all the four set to a single ek-04 mini controller?

Probably.

Will they be connected in series or in parallel?

 

Probably.

Will they be connected in series or in parallel?

in parallel ....

 

in parallel ....

Sounds good. This setup is more likely to work.

 

Sounds good. This setup is more likely to work.

Thank you buddy ...

 

Guys,

I too bought 3 sets of multi-color (red, blue, green, yellow) LED strings from China....

On all 3 sets, the red and yellow LED's work fine, the green and blue are DOA.

Any ideas on how I could check for a logic, wiring or LED fault please ? It seems strange that all 3 sets are showing the same fault.

Thanks in advance.

Andy

 

Hello zibbin

Have you finally connected the 4 sets Xmas led lights to one controller?

I want to do it but I am not sure about if the controller will work property.

Regards