Need help on In-Vehicular networks

Discussion in 'The Projects Forum' started by vivek20055, Oct 28, 2013.

Thread Status:
Not open for further replies.
  1. vivek20055

    Thread Starter Member

    Nov 4, 2012

    I am working on In-vehicular networks.

    In my project I need to know the message transmission latency in (In-Vehicular networks) from one CAN bus network to other CAN bus network.

    simply message transmission delay in (In-vehicular networks) through gateway.

    Can any one suggest me some idea about it or can you give me the link of information about it?

    Thanks in advance
    Vivek Alaparthi
  2. mcgyvr

    AAC Fanatic!

    Oct 15, 2009
  3. vivek20055

    Thread Starter Member

    Nov 4, 2012

    Thanks for your reply. Yes, I googled it.
    I know how to find latencies in CAN bus. I already designed a tool for that.
    But I am trying to expand the tool for vehicular networks.
    If you know how to design tool for two CAN buses connected with a coordinator (gateway). Then give me idea.

  4. Wendy


    Mar 24, 2008
    The owners of All About Circuits has elected not to host discussions of automotive electrical system modifications/enhancements due to safety concerns, the potential of legal ramifications and the possible circumvention of vehicle regulations at the state and federal level.

    This thread is against the AAC forum rules, Chapter 6, as seen here:

    This can be found in our Terms of Service (ToS)

    Automotive modifications of any kind are strictly forbidden. Therefore, this thread will be closed.

    Please try to understand the reasons behind this action, and feel free to browse and use the forums.

    You might find answers to your questions in one of these forums:

    Another good forum that shares many of the same membership is . Good luck.
Thread Status:
Not open for further replies.