Need help on a intelligent voltage charge

Discussion in 'General Electronics Chat' started by podgymax, Oct 19, 2008.

  1. podgymax

    Thread Starter Member

    Oct 19, 2008
    25
    0
    I am working on a project in which I need to build a 48V voltage charge with switching mode.

    I plan on micro-controller using a 8051. I don't know where to start, what would be required, and how to build it.

    I can read diagrams and build circuits, but as far as designing them and knowing what I need to use I don't have much knowledge. I am just wondering where I can aquire this knowledge, or if anyone here can help me build this circuit.

    Any help or recommendations would be greatly appreciated!!!

    thank you everyone!
     
  2. hgmjr

    Moderator

    Jan 28, 2005
    9,030
    214
    Are you receptive to using a PIC or an AVR? You can save a lot of money on the development tools over the 8051.

    hgmjr
     
  3. podgymax

    Thread Starter Member

    Oct 19, 2008
    25
    0
    My objective is to develop a low cost micro-controller based intelligent battery charger for electric vehicles. Then I don't have another requirement. Could you please help me?
    Any help or recommendations would be greatly appreciated!!!
     
  4. jackstone20

    New Member

    Oct 20, 2008
    1
    0
  5. podgymax

    Thread Starter Member

    Oct 19, 2008
    25
    0
    I can't design the circuit. I would appreciate it if anyone could give me a hand. thx
     
Loading...