Need advice on Projector Disassembling

Discussion in 'The Projects Forum' started by Stat7, Jul 19, 2013.

  1. Stat7

    Thread Starter New Member

    Jul 19, 2013
    1
    0
    I have disassemebled a Pico Projector and I want to keep the projection module separate from processor board which are connected by three ICs. Basically something like a ribbon cable 1 feet long which allows me to connect the module and the board in an extended fashion would be perfect. I have added an image (the three open ends go into the ICs below - this is connection I want to extend). Is this possible? How can I do this?
     
  2. mcgyvr

    AAC Fanatic!

    Oct 15, 2009
    4,770
    970
    yeah good luck with that..
     
  3. wayneh

    Expert

    Sep 9, 2010
    12,126
    3,048
    Somewhere between really hard and impossible. You'd need a male-female extension ribbon with the particular footprint or whatever it's called. Not likely, IMHO.
     
  4. Kermit2

    AAC Fanatic!

    Feb 5, 2010
    3,789
    945
    You can map out the connections and replace them individually one by one with wire of the length you require.

    Brand new issues with radiated freq's and impedance delays are sure to follow.

    I'd love to see that hack if you attempt it though :)
     
Loading...