Connector that would connect high current buss bars to circuit board or cable.

Similar to picture from junk box.

Wider connectors for more surface area would be good.

For perspective, bars are 16mm cc. About 4mm (only) deep to grab on to.

I'm thinking like common 1/4" qc terminals but open ended.

~15 amp load.

 

Connector that would connect high current buss bars ...

I don't think you'll get much help without a good picture of your connectors, and or more details. Where are these "high current buss bars" coming from?

 

I see there is not much for scaling. I'll try a better picture. It's for a small power tool. Universal motor. About 15amp max.

I'm thinking that I'll have make something from a square washer and screw from a terminal strip.

 

Still looking.

#16awg shown