hello there
I have a ATMEGA8 that I flashed with a AVR programmer. I think I messed up some of the Fuse bits unintentionally .
Now the the code I had flashed runs fine (without any external crystals) but I cannot re-flash (reprogram) the that microcontroller.
the programmer just refuses to identify anything is in its socket!
No, the programmer is okay as it can program other MCUs.
I am assuming I may disable the Serial programming interface of the MCU
If you think there could be some other problem please notify me.
is there anyway i can re-program the MCU to be used again?
I have a ATMEGA8 that I flashed with a AVR programmer. I think I messed up some of the Fuse bits unintentionally .
Now the the code I had flashed runs fine (without any external crystals) but I cannot re-flash (reprogram) the that microcontroller.
the programmer just refuses to identify anything is in its socket!
No, the programmer is okay as it can program other MCUs.
I am assuming I may disable the Serial programming interface of the MCU
If you think there could be some other problem please notify me.
is there anyway i can re-program the MCU to be used again?