LED driver configuration help

Discussion in 'The Projects Forum' started by kaznov, Feb 25, 2013.

  1. kaznov

    Thread Starter Member

    Mar 10, 2012
    30
    0
    Hi guys i'm designing brightness control system for indoor room using LED light room 110 vac
    so am using adriono board with atmega 328 but I was thinking the only device that can give me a high current up to 1 A to light up the LED light which is 110vac but looking at " HIGH CONSTANT CURRENT LED DRIVER " DD311 which is the chip am using its datasheet is kinda confusing ffx one of the pin is for reset is conected to a squarewave input !!!

    any help or advise please ?

    Thnaks
     
Loading...