I am having an issue understanding the Datasheet for the THE LCC100 CLAIR IC.
I am looking at the Input Control Current to Activate and it states a maximum of 8mA. So if I am going to power this IC with 1 AA battery and if my math is correct. I would need a 187 Ohm resistor (1.5V/.008A=187) between the input and the battery?
When looking at this Datasheet what other information should I pay close attention to?
Where can I look to see exactly what can go through the NC/NO contacts as in Amps and Volts?
Thanks again for your help, as I am jumping into this new world of electronics.
R/S
Patrick
I am looking at the Input Control Current to Activate and it states a maximum of 8mA. So if I am going to power this IC with 1 AA battery and if my math is correct. I would need a 187 Ohm resistor (1.5V/.008A=187) between the input and the battery?
When looking at this Datasheet what other information should I pay close attention to?
Where can I look to see exactly what can go through the NC/NO contacts as in Amps and Volts?
Thanks again for your help, as I am jumping into this new world of electronics.
R/S
Patrick
Attachments
-
143 KB Views: 16