Hello everyone

this my first post here hope it wouldn't be the last

my question is about this circuit

and

Member "Audioguru" was commented on the post here with them and want to ask him or anyone who can help me also if it can work as FM Receiver ?

If it doesn't Can give me another one worked and looks like it . Unfortunately required only analog in circuit

Have a project after 5 days ... Hope can help me,Thanks

 

No its an AM receiver...


FM here...
http://electronics-diy.com/TDA7000_FM_Receiver.php

 

hmm .. Can provide me with Simple FM Receiver ?

 

Hello,

On this page of the EDUCYPEDIA you will find some links on AM and FM recievers circuits:
http://educypedia.karadimov.info/electronics/radiotuning.htm

Bertus

 

Thanks Bertus

If u have another choose it will be fine

 

It can detect FM by slope detection. Just tune to one side of the FM signal's center frequency and you should be able to hear the modulation. A classic FM receiver has two slope detectors, one for each side of the center frequency and outputs the difference between them.

http://electriciantraining.tpub.com/14184/css/14184_163.htm

 

I hate to say it because it has very poor performance but a Super-Regenerative FM receiver (one transistor plus an audio amplifier) can pickup local AM or FM signals.
It slope-detects the FM (with lotsa distortion).

Its bandwidth is too narrow (causing distortion) or too wide (causing crosstalk with a few stations). It is overloaded easily by strong local stations so it must have its feedback fiddled with. Because it detects AM and FM at the same time then it picks up static interference noise. It causes interference to other radios.