I checkt,it's not broken in the midle. Just at the end i cut off

 

I check them with multimerer,they are solid

 

I payed that school once...i was connecting ADSL modem for some naibor. After 3 hours of mind blowing i checkt cable....

 

So first check the thread u posted at first. That thread has the color coding clearly labelled by another member.

Did u try that ?
Like to know if that was applicable for ur system. The model is different but the remote is almost the same the way I see it. The cable coding may be the same too.

Tell have u gone thru that ?

*Funny thing is tht now I cannot find that posts. I could have sworn I did see some fine pics and labellings before.

 

I chekt that first,before i posted anything...it's not the same wire color and it is 2.1 system ,my is 5.1

 

Dont wanat to mess up something,dont know wire coding....

 

http://forum.allaboutcircuits.com/attachment.php?attachmentid=41427&d=1333025261
You ment this? Nice job but not for my system.
My goes on remote(from headphone jack):
1.Blue
2.Black(shield)
3.Red
4.White
5.Yelow
6.Black
7.Light blue
8. Gren

 

OK..now this is gonna be a bit difficult. So do this I will need the solder side of the whole amp PCB. need to find out where the track leads.

Also get me the solder side of the remote.

Need to be of high resolution so I can zoom in without pixelation.
I will be here all night from time to time.

So get 'em pictures.

 

Sory but i cant do it today,im off to traning and than to work. Ill get them tomorow. Tnx for helping me

 

MY friend have DSLR cam ill get him to take pic to send you. That's the best i can do

 

 

 

Can't get that DSLR but this i thik should do it. If you need beather i wil find beather cam.

 

Pictures are OK I guess. I can check later tonight.

Check back after a few hours

 

What do you think is better solution. To go directly on the PCB or to make new 9 pin mini din?

 

Direct PCB will be secure and difficult and some what messy.
If u can find a compatible 9 pin DIN connector then I wud say go for it.

 

See the attached pdf......
Label 'em properly or gimme the IC no.s

 

from up arrow
1. 41AET8M
rc455BP
2. 41AET8M
rc455BP
3. 41AET8M
rc455BP
4. 41AET8M
rc455BP
5. 302004
M51132L
6. 302004
M51132L
7. 302004
M51132L

 

U need something else?

 

Nope.!
Just got my hands full this week end