Hi All,
I need to take a feed from the remote pictured below, to start/stop a camera recording so it can be operated elsewhere with a push to make switch.
Its the top left hand button just under the IR, is it just a case of drilling a hole in each of the two lines going into the button and then soldering in a wire into each?
I need to take a feed from the remote pictured below, to start/stop a camera recording so it can be operated elsewhere with a push to make switch.
Its the top left hand button just under the IR, is it just a case of drilling a hole in each of the two lines going into the button and then soldering in a wire into each?
Attachments
-
64.3 KB Views: 19