Im lost! Looking for Help on Motor controller and Board development

Discussion in 'General Electronics Chat' started by KarlHanson, Feb 2, 2010.

  1. KarlHanson

    Thread Starter New Member

    Feb 2, 2010
    1
    0
    Hello All,

    I'm developing a energy efficiency product and am at the point where I get Lost.

    My product has two motors that have to be controlled;

    vacuum motor -120vac/60hz 1.2 amp, need on and off limit control only

    actuator motor- 1/64 hp 120vac/60hz time delay and on and off limit control

    These are both nothing fancy.

    My product also has the need for receiving inputs :

    input pressure sensor
    output pressure sensor
    input temp sensor
    output pressure sensor
    (I need the board to be programmable to interpolate the T and P sensors to develop differential information, and record if possible and also allow for system to shut down/turn off/and report warnings)

    Amp metering sensor
    24vpower on and off sensor

    (I need the board to be programmable to interpolate the these sensors to record if possible and also allow for system to shut down/turn off/and report warnings)

    In conclusion,

    I do not know where to go from here! I have many details and a product completed! Except for the controls. and final Contols cost!

    Please help I will even give my phone number out to get this complete <snip>

    Moderator's note: Please keep questions and answers in the public forum.
     
    Last edited by a moderator: Feb 3, 2010
Loading...