IEC 61000-4-5 Generator Modelling

Discussion in 'General Electronics Chat' started by Gavin, Sep 30, 2009.

  1. Gavin

    Thread Starter New Member

    Sep 18, 2009
    10
    0
    Hello:

    Is anyone out there familiar with the IEC 61000-4-x standards?

    I'm interested in modelling the 1.2/50u & 8/20u combination wave generator described in the IEC 61000-4-5 (Surge) standard. Unfortuneately the values (resistor, capacitor, inductor) of the model are not provided. The values for the 10/700u model are provided.

    I figure I'd see if anyone else out has experience with these standards before I start experiementing from scratch.

    Any ideas or comments are welcome.

    -Gavin
     
  2. webbie

    New Member

    Jul 21, 2010
    2
    0
    I know this reply is a little late, but I have also been battling with a combination of components to provide the answer. I guess it should be possible to calculate the values, but trial and error seems to get me closer, although not close enough!

    I wonder why the reluctance to provide typical values?

    Steve.
     
  3. Gavin

    Thread Starter New Member

    Sep 18, 2009
    10
    0
    A late reply is fine with me, at least I know I'm not the only one trying to understand this! Unfortunately I didn't get an answer and opted to actually do the testing.

    Regards,
    Gavin
     
Loading...