All About Circuits

how to apply current LOAD in Simulink

H

Thread Starter

hameeds01

Joined Oct 22, 2009
1
i want to ask how to apply current Resistive load (ie 4A, 5A , 6A) at the out put of this system in Simulink?? ,if the out put of this system is Voltages
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
R How To Apply negative 130v DC to P Channel MOSFET ? General Electronics Chat 1
D Is it safe to apply MG Chemicals 419D Conformal Compound To This Display Board? General Electronics Chat 2
J Circuit Test in Lab: Apply 12.2V to votlage divider and when I connect LM1117 5V fixed to that divider voltage drops Test & Measurement 22
Xin_99 Filter should be apply after or before amplify? Homework Help 7
IKCTRAJAN what voltage we should we apply to diode for it's reverse (leakage) current test? Analog & Mixed-Signal Design 31
Similar threads
How To Apply negative 130v DC to P Channel MOSFET ?
Is it safe to apply MG Chemicals 419D Conformal Compound To This Display Board?
Circuit Test in Lab: Apply 12.2V to votlage divider and when I connect LM1117 5V fixed to that divider voltage drops
Filter should be apply after or before amplify?
what voltage we should we apply to diode for it's reverse (leakage) current test?

You May Also Like

Top