Help with Multisim

Discussion in 'Electronics Resources' started by daves2ng, Jul 8, 2010.

  1. daves2ng

    Thread Starter New Member

    Jun 17, 2010
    2
    0
    Hi, please I have a software for electronic simulations on my system but recently tried to perform a simple simulation of a power supply but couldn't find variable resistor. is there anything else that can be done or probably another component that will perform the same function? the version of multisim i am using is 10. thanks
     
  2. Georacer

    Moderator

    Nov 25, 2009
    5,142
    1,266
    Do you want to perform an analysis based on multiple values on a resistor? If so you can use the Simulate->Analysis->Parameter Sweep option. You can specify the value range for a specific element and the type of the simulation you want to run.
    All that referred to version 11 of the software.
     
  3. retched

    AAC Fanatic!

    Dec 5, 2009
    5,201
    312
    Or you can replace the resistor value every time you run a new simulation.

    Id go the sweep route ;)
     
Loading...