Hello, I have enclosed a photo of the circuit that I am developing.
I am struggling to get the stepper motor working. It is triggered with the 1st analogue input( LDR)
I have researched the pin configuration online but most other computer software uses different symbols for the stepper motor driver and it is rather confusing. I am using the Circuit Wizard software.
Have I set up the 16 pin DIL(l293d) in the right way?
Do you have any sample circuits that show the stepper motor working? or is there any way you can give me feedback on my circuit so I can get the stepper motor working?

Any help would be greatly appreciated.

Thanks

 

this is the area of the circuit in question