help for using a monster motor shield...

Discussion in 'Analog & Mixed-Signal Design' started by saintofinternet, Jul 19, 2016.

  1. saintofinternet

    Thread Starter New Member

    Jul 19, 2016
    3
    0
    hello,

    i have recently bought a Monster Motor Shield from Sparkfun ( https://www.sparkfun.com/products/10182 )

    they have included a code on that page which i tried but is not working for unknown reasons.

    i got the following link : https://github.com/OliviliK/Arduino-Robot/tree/master/libraries/Vnh2sp30 by Olavi and it runs just perfect with the same motor shield.

    my primary objective is to use the Motor Controller with RC (FrSky) inputs through an arduino. i am not a programmer hence it is getting diffcult for me to understand the code. the best i can understand is the PIN diagram as per the schematics and using it accordingly is yielding no results.

    requesting someone from this forum to help me out please.
     
  2. GopherT

    AAC Fanatic!

    Nov 23, 2012
    6,061
    3,830
    What is frsky?
     
  3. saintofinternet

    Thread Starter New Member

    Jul 19, 2016
    3
    0
Loading...