Hammer ez680

Discussion in 'General Electronics Chat' started by Roberter, Sep 8, 2010.

  1. Roberter

    Thread Starter New Member

    Sep 7, 2010
    1
    0
    Hi There,
    I have a HAMMER EZ680 energizer unit for our Electric Fence, which has now lost power on two of the three electrified strands.
    On inspection I have found that one of the outputs in the unit has no voltage, there are three outputs, from the left there are RED – BLACK – RED, it is the left RED that is not working.
    Can anyone help either with advice or where I can obtain the Manual or instruction book, I have tried the internet with no success.

    Contact info;



    Kind Regards,
    Robert
     
    Last edited by a moderator: Sep 8, 2010
  2. marshallf3

    Well-Known Member

    Jul 26, 2010
    2,358
    201
    I saw nothing online either, you might try writing the company so see if they'll attach a schematic to a reply e-mail.

    IF you can get the back off of it I'd just look for the obvious, chances are there's only one HV circuit that gets divided through resistors to feed the red posts. I'll assume the black one is the ground teminal?
     
    Roberter likes this.
Loading...