Hall effect sensor in proteus

Discussion in 'The Projects Forum' started by AaraAbdas, Dec 22, 2012.

  1. AaraAbdas

    Thread Starter New Member

    Dec 11, 2012
    5
    0
    Hey

    I am making a convertor and in that circuit i have to sense current and voltage at input and output. I am trying to use hall effect sensor. But my simulation are working right.. i am getting these errors when i run it on proteus v.7

    my schematic is here
     
  2. absf

    Senior Member

    Dec 29, 2010
    1,492
    372
    Was it working without the sensor?

    What is being sent out from your PIC18F ?

    From the message, it looks like you cannot run in animation mode. May be you can try in graph mode plotting a graph on certain strategic points.

    I've never seen this type of error before....:D

    Allen
     
Loading...