Hi.,
Am doing GPS receiver based project. i could integrate the GPS with EVK board. Buti can't receive any characters from GPS. GPS and EVK interface with UART communication. i set a baud rate 4800bps , No parity bit, 0 START BIT, 1 STOB BIT,NORMAL channel mode. So i could not Predict my problem.My GPS receiver is NMEA protocol supported.
Please any solution to complete my project as soon.




Best Regards.,
JANU.S

 

The first thing I would do. Download the manual for the GPS unit. And find out what is says about the communication setup. Like voltage levels and default serial port configuration. We can not read your mind. So you must also post descriptions detailed enough. In order for us to "replicate" your setup.