Hi all,

i'm doing a sensor project... but i have a problem to load my program into PIC..

My program is successfully without an error.. then my .hex file also generated successfully... but when i'm try to connect to PIC using MikroBootloader, the message below appear:

Error:- Timeout waited for PIC
Disconnected

The port and baud rate already set correctly...The Tx button=green, but Rx button=red....

Hope u all can help me...Tq.

 

try to swap the Rx and Tx lines... worth a shot.

 

swap the Tx and Rx lines? How to do that??..

 

Perhaps a stupid question, but is the bootloader loaded into the pic flash memory?