Colleagues,
I’d like to make a board where some of the vias are on SMT pads. I’m aware of the potential assembly problems, which via-in-pad might cause. My circuit will be hand assembled.
When I try to make via-in-pad, Eagle generates a pop-up message “can’t set via to layer 1”, or draws a big yellow X on the layout.
Is it possible to suppress this error in Eagle layout?
Any suggestion, insight or reference is really appreciated!
Cheers,
- Nick
Update: Parallel thread https://forum.sparkfun.com/viewtopic.php?f=20&t=33244
I’d like to make a board where some of the vias are on SMT pads. I’m aware of the potential assembly problems, which via-in-pad might cause. My circuit will be hand assembled.
When I try to make via-in-pad, Eagle generates a pop-up message “can’t set via to layer 1”, or draws a big yellow X on the layout.
Is it possible to suppress this error in Eagle layout?
Any suggestion, insight or reference is really appreciated!
Cheers,
- Nick
Update: Parallel thread https://forum.sparkfun.com/viewtopic.php?f=20&t=33244
Last edited: