Hey guys!

I'm working on a timing project and I'm kind of in a rush.. It needs to be done in about 2 weeks, 3 weeks max.. I'm using a BS2, and a MAXIM DS1393 - Along with a Visual Basic Program.

I'm currently working on the board/schematic using the Eagle CAD PCB Editor.

Here's the problem. The DS1393 is an SOP Chip. I've built a couple lbr files before. Some have turned out good, some okay, and some - just plain horrible.. The problem is: I'm somewhat inexperienced with Eagle. If it's a fairly big part, with easy dimensions, I'll do fine with building a lbr file. Except this one is just plain too hard for me..

I was wandering, if it wouldn't take too much of your time, for someone to quickly build a DS1393 lbr file for me.....

I know it sounds crazy, lol, but I just can't do it.. It's too confusing for me.

Any help would be greatly appreciated..

Thanks!
Ryan

 

Which version of Eagle are you using? Shouldn't matter but nice to know..

By DS1393 I assume you mean the one in package 21-0061?

 

Taken from Maxim datasheet 19-4898 Rev 3 using Eagle 5.2.0
Check it carefully before using!

You're right, it takes awhile to generate a new component especially if you haven't done it in awhile.. I needed the refresher plus its HOT outside in TX.

Hope it does the job for you.. if not, you can edit the symbol/package as desired.

 

Thank you so much! I really do appreciate this! It is perfect!

Thanks again!
-Ryan!