Driving a stepper motor

Status
Not open for further replies.

Thread Starter

ABShah

Joined May 17, 2011
9
Hi, I am working on a very simple and basic project that uses a micro controller 8051 to drive a 0.5 ampere 6 wire stepper motor with a resolution of 7/.5 degrees. To drive the motor I have to use a driver UCN5804/. Can any one please help me with the schematics? I can not understand how to interface the driver IC with MC and the stepper motor. I have a very weak knowledge of electronics so please I would like someone to help with an easy schematic and a little bit understandable detail.
I would really appreciate the help. Thanks
 

Thread Starter

ABShah

Joined May 17, 2011
9
I also want to know, how to hook it up with both the micro controller as well as the stepper motor. how to find that?
 
Status
Not open for further replies.
Top