Delaying a Monetary Relay Pair

Discussion in 'General Electronics Chat' started by Li Andy, Jun 6, 2015.

  1. Li Andy

    Thread Starter New Member

    Jun 6, 2015
    Hi people,
    I am using a 4CH receiver in a project I am working on.
    So far so good, I have everything working as I want.
    2CH (low current relays) used to control 2 relays (hi) which flip polarity to a 12VDC motorized actuator depending on which button is pressed on transmitter, and again working fine.

    BUT, I feel the momentary latch is slightly too long....
    So my question, the answer with least complexity, components.
    How to..
    • reduce the latch time of relays.
    • delay initial latch of relays.
    I think some of you will get the idea. :)
  2. dl324

    Distinguished Member

    Mar 30, 2015
    Post a schematic, the delay time you're seeing, the delay time you want, the current you're switching, and any other relevant details.