CX Programmer and Profinet configuration

Discussion in 'Embedded Systems and Microcontrollers' started by arpix, Oct 27, 2011.

  1. arpix

    Thread Starter New Member

    Oct 27, 2011
    2
    0
    Hi all!

    I need some advice with some of PLC programming.

    Im making one configuration with Profinet comunications!

    This is what i have Omron PLC:
    CJ1M CPU13
    CJ1W PNT21
    CJ1W TERO1
    GRT1-PNT
    GRT1-ID4-1
    GRT1-OD4-1
    GRT1-END
    GRT1-PNT
    GRT1-AD2
    GRT1-DA2V
    GRT1-END

    Ok i had made a configuration in CX-Configurator. And my cards i/o cards are conected.

    But i dont know how to activate one of the Digit Out on OD4-1 card.

    Can someone put me some exaples how to do it in CX programmer?
    And maby one exaple how can i reach the address and activate the transistor output on that card.

    Thank you for help and advice!

    Best regards Arpad
     
  2. panic mode

    Senior Member

    Oct 10, 2011
    1,319
    304
    you should ask PLC related questions in PLC forum.
    there is excellent one with dedicated Omron section at www.mrplc.com
     
  3. arpix

    Thread Starter New Member

    Oct 27, 2011
    2
    0
    Thanx bud!
     
Loading...