Hi,
I am new to electronics and attempting to manufacture my own PCB. I have created a simple circuit using multisim, then drew the PCB layout using ultiboard. The problem I am having is the printing of the circuit, I want to use a print out to transfer the circuit onto a light sensitive copper board. When I preview or print my circuit it is incredibly small, and does not seem to match the dimensions shown on the computer. Any advice would be much appertained.
Regards,
Jay
I am new to electronics and attempting to manufacture my own PCB. I have created a simple circuit using multisim, then drew the PCB layout using ultiboard. The problem I am having is the printing of the circuit, I want to use a print out to transfer the circuit onto a light sensitive copper board. When I preview or print my circuit it is incredibly small, and does not seem to match the dimensions shown on the computer. Any advice would be much appertained.
Regards,
Jay