Hello,
I am extremely new to circuits and circuit simulation software. I am trying to make a circuit that uses a voltage controlled voltage source(I believe), but the image that PSPICE wants me to use is not what I have written down on the drawn one. there are 4 inputs/outputs on PSPICE, while normally there is just one on either side. How should I go about doing this? Any help would be greatly appreciated!
I am extremely new to circuits and circuit simulation software. I am trying to make a circuit that uses a voltage controlled voltage source(I believe), but the image that PSPICE wants me to use is not what I have written down on the drawn one. there are 4 inputs/outputs on PSPICE, while normally there is just one on either side. How should I go about doing this? Any help would be greatly appreciated!