Connector (flag) symbol in schematic?

Discussion in 'Electronics Resources' started by bkochis, Mar 20, 2011.

  1. bkochis

    Thread Starter New Member

    Aug 5, 2010
    19
    2
    I am trying to determine where a 'flag' symbol is in Eagle?

    See attached image for what I am talking about. Not sure 'flag' is the correct term.

    Thank you
     
  2. HallMark

    Member

    Apr 3, 2011
    89
    5
    Are you sure that this schematic is made in EAGLE? as this symbol is also available in PROTEL- PCB Design Software and in that software it is named as "PORT" and used to connect the signal in between two different sheets.
     
  3. jpanhalt

    AAC Fanatic!

    Jan 18, 2008
    5,699
    907
    Look in "supply2" near the bottom, there are "V-->" and "V<--" that allow you to use them as flags.

    John
     
    HallMark likes this.
  4. bkochis

    Thread Starter New Member

    Aug 5, 2010
    19
    2
    Hallmark, I wasn't sure this was produced in Eagle. I was hoping that someone had already created something.

    jpanhalt, Thank you this was exactly what I was asking for.

    Bob
     
    HallMark likes this.
Loading...