compensator in pspice

Discussion in 'General Electronics Chat' started by rakesh.shetty, Oct 16, 2013.

  1. rakesh.shetty

    Thread Starter New Member

    Oct 16, 2013
    1
    0
    how to see in pspice that my compensator design is working properly or not??????
     
  2. LvW

    Active Member

    Jun 13, 2013
    674
    100
    The answer is very simple:
    Simulate the whole control loop with and without the compensator - and check if you meet the requirements for stability and time response.
     
  3. crutschow

    Expert

    Mar 14, 2008
    12,991
    3,226
    One way is to do a Bode plot (gain and phase) of the circuit open loop response and check if the gain and phase margins are adequate.
     
Loading...