Building a UV Socket Light from a Kit

Discussion in 'The Projects Forum' started by Seaker, Jun 29, 2013.

Thread Status:
Not open for further replies.
  1. Seaker

    Thread Starter Member

    Feb 3, 2013
    32
    0
    Hello;
    I purchased a kit off of E-Bay to make up a 38 Led UV Light for another project that I have going on. The kit arrived but had no instructions on how to wire up the LED's. I am guessing that the connections will be in series with the negative led of the LED going to the positive led of the next LED and so on until complete. The kit also contained a small rectifier board which has the
    components needed silk screened on it so I am fine there.
    If someone could please advise if the LED wiring is correct.
    I have an image of the Kit minus the bulb shown here:
     
  2. t06afre

    AAC Fanatic!

    May 11, 2009
    5,939
    1,222
    Seaker likes this.
  3. bertus

    Administrator

    Apr 5, 2008
    15,641
    2,344
    Hello,

    As I do not see any transformer for isolation,
    I am closing this thread as it violates AAC policy and/or safety issues.

    Quote:
    6. Restricted topics.

    The following topics are regularly raised however are considered “off-topic” at all times and will results in Your thread being closed without question:

    • Any kind of over-unity devices and systems
    • Automotive modifications
    • Devices designed to electrocute or shock another person
    • LEDs to mains
    • Phone jammers
    • Rail guns and high-energy projectile devices
    • Transformer-less power supplies
    This comes from our Tos:
    Terms of Service

    Bertus
     
Loading...
Thread Status:
Not open for further replies.