Brushless motor controller

Discussion in 'General Electronics Chat' started by shianhugg, Sep 25, 2013.

Thread Status:
Not open for further replies.
  1. shianhugg

    Thread Starter New Member

    Sep 24, 2013
    11
    1
    I need some help designing a project. I need a PCB that will control a brushless 12v DC motor (so 3 phase) from a 12v input. The motor is rated at 15A 12vdc, I need the motor to either be off or run at 100% no variable control. The circuit board will have constant 12vdc source from a battery, ground, and a 12v switched wire that will allow me to turn on and off the system. It basically is a relay that converts from single phase to 3 phase. Can anyone please help me.
     
  2. Georacer

    Moderator

    Nov 25, 2009
    5,142
    1,266
    I already just closed one thread of yours for asking information on modifying a street vehicle. This is not allowed by the Terms of Service of the forum, to which you agreed upon your register.

    This isn't about the looks and what is spelled in the thread, it is about its content, visible or not. Please do not bring this topic up anymore. Otherwise, action will be taken against you.
     
Loading...
Thread Status:
Not open for further replies.