Broadband xmfr design with inductive element on same core?

Discussion in 'The Projects Forum' started by electronice123, Mar 23, 2013.

  1. electronice123

    Thread Starter Active Member

    Oct 10, 2008
    Hello everyone,

    After a tremendous amount of study I have learned how to design low power broadband transformers which provide clean output waveforms with very little distortion.

    I want to design a broadband xmfr with an inductive element on the same core (I like challenges) so that I can get it to operate in continuous conduction mode. I'm just wondering if anyone here could point me in the right direction as far as literature and information go? And tell me how difficult this design would be, if it's even possible.
  2. DickCappels


    Aug 21, 2008
    You already have an inductive component, but it is probably very small. As you decrease the coupling between your primary and secondary (assuming a simple transformer) you will see leakage inductance appear. If that's what you are after.