Hi

I have a couple of devices that have prototyping areas.

I have a low pin demo pickit board

I just wondered what wires people used.

The holes are a bit too big for my usual wires that push into a breadboard (the sheathed coloured ones)

Thanks

 

I use Kynar wire, tinned, single strand, multi-colours
I assume you want to solder the wires into the proto board PCB.?

http://www.ebay.co.uk/itm/Unistrand...2-Metres-/121128595254?_trksid=p2054897.l4275

Is this your PCB type.?
http://www.rapidonline.com/Electron...rce=googleps&gclid=CLnA-IS5wb0CFYbMtAodkWgASw

 

Hi

I don't want to solder them, I just want to 'plug and play'

and then unplug..

This board

http://media4.rsdelivers.cataloguesolutions.com/LargeProductImages/R0149922-01.jpg

Cheers

 

You need to solder those boards, the idea is that you solder components to the board and solder wires to the pads/component legs.

 

You could buy a small plug-in style breadboard like this;

And just stick it to your PCB with some double sided padded adhesive tape. I think it might fit.

You can buy these "tiny breadboards for electronics" anywhere, a google search shows zillions of sellers.

 

These are handy, http://www.ebay.com/itm/350882445609?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649
you can get male/male or female/female as well.
Max.

 

Hi

I don't want to solder them, I just want to 'plug and play'

and then unplug..


Cheers

If using soldered module boards I would suggest strip boards, http://www.futurlec.com/Protoboards.shtml
Half way down the page.
Interconnect by the leads in the ebay link I posted or use IDC ribbon.
Max.