Hello forum. I had a qick question about a project I'm thinking of doing.
So I wanted to make a poker table. I know how I'm going to do that, but I wanted to make a built-in dealer chip. So I was planning to put 8 LEDs (One for each station/person) And at one station there would be an Push button. I want one LED to be lit up at a time, and when the button is pushed, I want the power to transfer to the LED to the right of where it previously was. Again: I only want ONE LED to by lit at a time.
I'll include a basic pitcure for a visual.
I think I'll need a demultiplexer and a counter, but not too sure how to use them.
thanks,
Jusstice
So I wanted to make a poker table. I know how I'm going to do that, but I wanted to make a built-in dealer chip. So I was planning to put 8 LEDs (One for each station/person) And at one station there would be an Push button. I want one LED to be lit up at a time, and when the button is pushed, I want the power to transfer to the LED to the right of where it previously was. Again: I only want ONE LED to by lit at a time.
I'll include a basic pitcure for a visual.
I think I'll need a demultiplexer and a counter, but not too sure how to use them.
thanks,
Jusstice