Hi there.
When i was soldering the one ending of this capacitor i see that the one landing of the board is gone. I want to connect this end of the capacitor to valid point.
Is there a way or to send the board to trash?
I find that the point i have showed are in equal space but are not connected by lines on the back side of the board.
I hope the things to be understandable.
screen grab
Thanks in advance
When i was soldering the one ending of this capacitor i see that the one landing of the board is gone. I want to connect this end of the capacitor to valid point.
Is there a way or to send the board to trash?
I find that the point i have showed are in equal space but are not connected by lines on the back side of the board.
I hope the things to be understandable.
screen grab
Thanks in advance